Cart 0
5.png
New Arrivals

WY ARC Series Polymer Clay Cutter | Clay Craft Tools | Arch Stamp | Debossed | ARCH #1

RM 9.00

PLEASE READ BEFORE PURCHASING 


★ PRODUCT & MATERIALS ★ 

These stamps are designed in my home-studio in Seri Kembangan and printed in 3D, so the shapes are truly unique. 

They are made of PLA, a biodegradable and biocompatible plastic that comes from renewable resources.  


Colour of the stamp is normally skin, white, but different colours could be used randomly.  


★ USE ★  

These stamps are specifically made for contemporary polymer clay and soap making. 

The embossing edge is approximately 0.2mm-0.4mm. 

Thus is fragile and please handle softly. 


The embossing section is up to 3mm. The stamp works on clay slabs of any thickness. I recommend to try the cutters on a scraps slab first do adjust pressure. 


To avoid clay to get trapped in the small edges, place a piece of cling paper between the clay and the stamp if needed.  


Press the stamp firmly but gently and evenly. Don't press too hard as some parts of the stamp are thin in order to obtain a defined embossing and the stamp might brake.  


If you are using a thin slab, don't press too deeply.  


If you are not using cling paper, some clay might get trapped in the small edges. Remove it with a toothpick or a needle and soapy water. *Do not use hot water* 


★ SIZES ★  

Measurements are taken at the widest or tallest part of the shape. Size is the 'inner' of the cutter. Please allow for a +/- 0.05mm variance. 

The embossing section is 3mm Width available: 

15mm 

20mm 


★ CARE INSTRUCTIONS ★ 

PLA breaks at high-temperature environments so please don't expose the cutters to the sun and don't leave them in high-temperatures. Do not wash in a dish-washer or under very hot water. Do not soak. 

Wash gently under warm water. Use a needles or toothpick to remove any clay stuck in the sharp/small edges.  


★ SAFETY WARNING ★ 

This product is not a toy and it's not suitable for children of any age.